Bernina 730 Instruction Manual Page 260

  • Download
  • Add to my manuals
  • Print
  • Page
    / 285
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 259
256 Embroidery Support – Messages
Possible Messages regarding the sewing
computer see page 189
•••••••••••
Messages
In special cases messages may appear on the
screen. They serve as a reminder, warning, or
confirmation of selected applications and
functions.
Below, the embroidery module messages are listed.
Message
The embroidery computer cannot change to sewing.
Please finish the layer and press the «Edit» button to
return to previous screen. You may now safely change to
sewing.
Hoop cannot be parked because the presser foot or need-
le is in the wrong position.
Please lower the feed dog.
Please use a larger embroidery hoop.
Card exchange was not accepted. Possible loss of data!
Please refer to your manual before exchanging cards.
The point lies outside the embroidery area.
The next stitch lies outside the embroidery area. Please
rehoop fabric and relocate the design.
Please reposition the Mega-Hoop to Upper (1) position,
raise presser foot and press OK to start calibration.
Please reposition the Mega-Hoop to Middle (2) position,
raise presser foot and press OK to start calibration.
Please reposition the Mega-Hoop to Lower (3) position,
raise presser foot and press OK to start calibration.
Please change the needle to the highest position.
Please attach embroidery module.
Embroidery module communication NOT working!
Embroidery design card NOT working.
Note
It is not possible to switch from
Embroidery Menu (Ready) to Sewing
mode. Press «Edit» to return to Edit
screen first.
Check presser foot and needle position.
Press the feed-dog drop key. The messa-
ge disappears automatically when the
feed-dog position was changed.
The embroidery design does not fit into
the attached hoop.
Do not remove embroidery card from
embroidery computer when in process.
Reposition design to fit into embroidery
area before starting to stitch.
Follow the instructions in the message.
Move Mega-Hoop to position 1 (top).
Move Mega-Hoop to position 2 (center).
Move Mega-Hoop to position 3 (bot-
tom).
Place needle into highest position by
hand.
The embroidery module must be
attached.
Check embroidery module/embroidery
computer connection.
Remove embroidery card and insert
again. Try other card if necessary.
032131.70.04_0509_a730_EN
Page view 259
1 2 ... 255 256 257 258 259 260 261 262 263 264 265 ... 284 285

Comments to this Manuals

No comments