Bernina 730 Instruction Manual download pdf (Page 151)

149Quilt Stitches – Applications

Freehand Quilting With BSR

(BERNINA Stitch Regulator) optional

Stitch:

Needle:

Thread:

Feed dog:

Presser foot:

Straight stich No. 1 or Zig-zag stitch No. 2

size and type suitable for the fabric selected

monofilament or cotton, embroidery thread, polyester

down (darning position)

BSR foot No. 42 incl. interchangeable soles (closed, open,

transparent)

BSR (BERNINA Stitch

Regulator) Function

The BSR presser foot reacts

to the movement of the

fabric under the foot and

controls the speed of the

sewing computer up to

the maximum speed possi-

ble. The following applies:

the faster the fabric is

moved the higher the

speed of the sewing computer.

If the fabric is moved too fast an

acoustic signal (beep) is heard. The

beeper can be turned on or off on

the «BSR» screen.

• BSR mode 1 is the active standard

• the sewing computer runs continu-

ously at a recuced motor speed, as

soon as the foot control or the

Quick Reverse button is pressed

•

moving the fabric under the foot

will engage the sewing computer

to accelerate

•

through the continuous needle

movement securing in the same

position is possible without pres-

sing an additional button

• touch the button «BSR2» to enga-

ge BSR mode 2

•

the sewing computer will only

engage if the foot control or the

Quick Reverse button is pressed

and the fabric is moved simultane-

ously

• the movement of the fabric deter-

mines the sewing speed

• for securing, the «Securing

Function» button must be pressed

•

touch the button «BSR1» to enga-

ge BSR mode 1

BSR function can be sewn in 2 separate modes of

operation

BSR Function With Straight Stitch

No. 1

This function using a special presser

foot allows for free-motion quilting

(sewing) using the straight stitch and

a pre-selected stitch length (up to

5mm).

A regulated set stitch length is main-

tained within a certain speed, inde-

pendent of the movement of the

fabric.

BSR Function With Zig-zag Stitch

No. 2

The zig-zag stitch can be used for

thread painting or fabric embellish-

ment for example.

The set stitch length will NOT be

maintained when sewing with the

zig-zag stitch, but the BSR function

simplifies the application.

Warning!

By activating the BSR function the sewing computer sews

either continuously at a reduced motor speed (mode 1,

standard) or one single stitch (mode 2).

As long as the BSR presser foot is illuminated red, adjustments like

threading and changing the needle, for example must not be carried

out, as the needle will engage while fabric is moved unintentionally!

Without fabric feed the BSR mode is turned off after approx. 7 seconds

and the red light goes off.

Please refer to the Safety Instructions!

For an even sewing

start (one single stitch)

the foot control must be

pressed and the fabric

moved simultaneously.

This also applies for

sewing points and

straight stitching within

a round form.

If the BSR function is

deactivated and later re-

activated without the

sewing computer being

switched off in bet-

ween, the last selected

BSR mode is active.

032131.70.04_0509_a730_EN

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 284 285

Comments to this Manuals

No comments

Bernina 730 Instruction Manual Page 151

Comments to this Manuals

Related products and manuals for Sewing machines Bernina 730