Bernina 730 Instruction Manual Page 17

  • Download
  • Add to my manuals
  • Print
  • Page
    / 285
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 16
15The Sewing Computer – Operating Instructions
Needle Threader
Bringing up the Lower Thread
if bobbin thread is cut on the cutter (page 13), there is no need to bring the
thread to the top of the stitch plate
hold the upper thread
sew one stitch:
normal sewing with presser foot down
by tapping on foot control with your heel, with presser foot up
pull the upper thread to bring the lower thread up through the stitch plate hole
take both threads through the slit on the presser foot to the back
pull threads over the head frame cutter
Thread Cutter
Thread Cutter on Head Frame
pull both threads from front to back over the cutter
the threads release as soon as the first stitch is sewn
Note:
The bobbin thread must be brought up through the stitch plate for
certain types of work. The length of thread is sufficient for most
normal work if the lower thread cutter has been used.
B
A
Removing the Needle
raise the needle
turn power switch to «0» (off)
lower the presser foot
loosen the needle clamp screw
pull the needle down to remove
Inserting the Needle
loosen the needle clamp screw, if needed
flat side of needle to the back
insert the needle as far up as it will go
tighten the needle clamp screw
Changing the Needle
Refer to the safety instructions!
!
Thread in Hook
lower the presser foot
lay the thread behind
hook B and hold
lightly
Lever Down
press lever A down
and simultaneously
guide the thread
around hook B to the
right to the needle
Thread in Front of
Needle
put the thread from
the front into the
guide until it catches
in the hook
Release the Lever and
Thread
let go of lever A and
thread
pull the thread loop
through the needle eye
032131.70.04_0509_a730_EN
Page view 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 284 285

Comments to this Manuals

No comments