Bernina 430 Instruction Manual download pdf (Page 65)

65

Preparing for embroidery

Hooping the fabric

Centering

• determine the center of the fabric to be

embroidered

• mark with a fabric marker or chalk

Using the embroidery hoop

• loosen the screw(s)

• remove the inner hoop

• the arrows on both hoops should match

• the arrows on the large, medium and

Mega-Hoop are in the centre on the

front, and the arrows on the small hoop

on the right

Hooping the fabric

• place fabric on top of the outer hoop

• place the marked center point in the

center of the template on inner hoop

• match the arrows of inner and outer

hoops

• place inner hoop on top of fabric and

outer hoop and press into place,

loosening screws to accommodate

fabric. Tighten screws

• remove template

Embroidery template

• there is a template for each embroidery

hoop

• the embroidery surface is marked in 3/8”

(1cm) squares

• the center and corners are marked with

holes for transferring marks to fabric

• place the template in the inner hoop so

that the word BERNINA is at the front

(by the arrows) and can be read

• the template will engage automatically in

the inner hoop

• there are finger holes for removing the

template from the small and medium

hoops, and special attachment clips for

the large hoop template

032907.52.04_0910_a430/a440/a450_EN

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 85 86

Comments to this Manuals

No comments