Bernina 430 Instruction Manual download pdf (Page 29)

29

Functions - Memory

Corrections in Memory

The contents of the Memory remain saved

even when the sewing computer is

disconnected from the electrical supply.

They can be recalled at any time.

Overwriting individual stitches, letters

or numbers

• press the

or left button and scroll

to the stitch you wish to overwrite

• select new stitch number / letter /

number, new stitch length/width or

needle position

• press

-button (to save)

• the original stitch is corrected (over-

written)

Deleting individual stitches, letters or

numbers

• press the -button or left button and

scroll until the stitch you wish to delete

appears on the display

• press the «clr»-button

• the desired stitch/letter/number is

deleted

Leaving Memory

• press the -button

• during the process of saving an

hourglass is visible on the display

• all entries are saved

• Memory closes

• the word «mem» disappears from the

display

Balance in Memory

• the contents of the Memory as a whole

can be balanced as follows:

• close Memory

• touch the Balance button

• open Memory, now balance

the entire contents of the Memory with

both needle position buttons

Delete complete Memory contents

• press the «clr»-button, keep depressed

and press the

• release both buttons

• leave Memory by pressing again

The contents of the Memory will be lost if

the sewing computer is switched off

without pressing the -button before

closing the Memory, as they were not

saved.

Stitch selection

• stitches1–10:

press the appropriate button; stitch

graphic and basic width and length

settings appear on the display

• stitches11–99:

press the #-button and the appropriate

number

• stitches from 100

press the #-button longer until a «1»

appears in display, then enter the last

two digits of the stitch

Select button 0 and stitch

No. 10 will be selected

(Standard buttonhole)

C

032907.52.04_0910_a430/a440/a450_EN

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 85 86

Comments to this Manuals

No comments