Bernina 430 Instruction Manual download pdf (Page 15)

Setting up the sewing computer

Inserting the bobbin

Clockwise turning of the bobbin

The bobbin must turn clockwise.

Inserting the bobbin

Insert the bobbin so that the thread winds

clockwise.

Pulling the thread under the spring

Pull the thread into the slit, then to the left

under the spring.

The bobbins are inserted and

threaded in the same way in

the aurora models 430, 440 QE

and 450.

Winding the bobbin

• turn power switch to «I» (on)

• place empty bobbin on spindle

Threading the bobbin

• place thread on spool pin

• attach appropriate spool disc - diameter

of thread spool determines disc size

• following the direction of the arrow, take

thread through the rear guide and

around the pre-tension stud

• wind the thread two to three times

around the empty bobbin and cut off any

excess thread on the thread cutter

• push engaging lever against bobbin, the

winder works automatically

• the motor will stop automatically when

the bobbin is full

Winding the bobbin while sewing or

embroidering

• place thread spool on vertical spool

then, following the direction of the arrow,

take thread through the thread guide

and around the pre-tension stud

Thread cutter

• pull thread over thread cutter when

removing the bobbin • then proceed as mentioned above

032907.52.04_0910_a430/a440/a450_EN

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 85 86

No comments

Bernina 430 Instruction Manual Page 15