Bernina 430 Instruction Manual download pdf (Page 70)

70

Requirements / Embroidery software

System requirements of your PC

Minimum requirements

Pentium 3 CPU, 800 MHz or higher

Windows XP Prof. and Home Service

Pack 2

256MB RAM, 2 USB ports,

500MB available space

8GB Hard Disk Memory,

16 Bit True Color Graphic Card

Recommended requirements

Pentium 4 CPU, or higher

Windows XP Prof. and Home Service

Pack 2

Windows Vista

512 MB RAM or higher, 2 USB ports,

20GB Hard Disk Memory,

750MB available space,

32GB or higher True Color Graphic Card

The «aurora» embroidery system is

operated by the BERNINA embroidery

software PC embroidery software and

directly on the personal computer by the

EC on PC software.*

* the term PC basically applies to PC and laptop

BERNINA embroidery software

The software is necessary to open and

edit (rotate, scale etc.) embroidery

designs.

Refer to enclosed CD-ROM for user

instructions.

BERNINA EC on PC software

(Embroidery Control on Personal

Computer)

The PC software EC on PC will be

installed automatically with embroidery

software. Motifs can be positioned and

embroidered with this software.

BERNINA embroidery software

BERNINA applies the widely used USB

technology to their Sewing/Embroidery

systems. In order to avoid undesirable

interaction between BERNINA’s individual

USB devices and other USB devices,

BERNINA recommends taking the

following precautions:

• Avoid turning the aurora Sewing/

Embroidery System or other USB

devices on and off in short intervals.

• When using an embroidery software

with dongle, do not unplug the dongle

while the software is running!

• During the embroidery stitch out

process, do not unplug the USB cable.

• Before turning off the aurora Sewing/

Embroidery System, always close the

embroidery software and then unplug

the USB cable.

• If you intend to use a USB HUB device

or other USB devices, BERNINA

recommends using the USB Standard of

Version 2.

• BERNINA recommends closing all

running computer programs while

embroidering wiht the embroidery

software / EC on PC programs.

Requirements for embroidery operations

When the aurora Sewing/

Embroidery System is in the

embroidery mode, the foot

control must be unplugged.

To avoid errors with embroide-

ry via personal computer no

virus scanner must be activa-

ted.

If the aurora 430 / 440 QE / 450

is connected to the computer

via a USB hub, the system can

cause difficulties when turning

off the aurora 430 / 440 QE /

450 with running embroidery

software (depending on the

PC configuration). These

difficulties are easily remedied

by rebooting the PC. Stitching

in the already started motif

can be resumed at the last

stitch with the function

«Embroidery sequence

control» and «Saved embro-

idery position» (see page 76).

032907.52.04_0910_a430/a440/a450_EN

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 85 86

Comments to this Manuals

No comments