Bernina 430 Instruction Manual download pdf (Page 45)

BSR foot - Application

Stitch:

Needle:

Thread:

Feed dog:

Presser foot:

Freehand quilting with BSR

Straight stitch No. 1

size and type suitable for the fabric selected

monofilament or cotton

down

BSR foot No. 42

• BSR mode 1 is the active standard

• on pressing the foot control or the

Start-/Stop button, the needle starts to

move continuously

• moving the fabric under the foot will

engage the sewing computer to accele-

rate

• through the continuous needle move-

ment securing in the same position is

possible without pressing an additional

button

BSR (BERNINA Stitch Regulator)

function

This function using the BSR presser foot

allows for free-motion quilting (sewing)

using the straight stitch and a pre-selected

stitch length (up to 4mm). The BSR

presser foot reacts to the movement of the

fabric under the foot and controls the

speed of the sewing computer up to the

maximum possible speed.

The following applies: the faster the fabric

is moved the higher the speed of the

sewing computer. A regulated set stitch

length is maintained within a certain speed,

independent of the movement of the fabric.

If the fabric is moved too fast an acoustic

signal is heard, provided the beeper

function has been previously activated.

(see page 46).

• press external button No. 2 of the stitch

selection (see page 29) to engage BSR

mode 2

• the sewing computer only starts if the

foot control or Start-/Stop button is

pressed and the fabric moved simulta-

neously

• the movement of the fabric determines

the sewing speed

• for securing, the «Securing function»

button must be pressed

• press external button No. 1 of the stitch

selection to engage BSR mode 1

BSR function can be sewn in 2 separate modes of operation

For an even sewing start (one single stitch) the foot control must be

pressed and the fabric moved simultaneously. This also applies for

sewing points and straight stitching within a round form.

When resuming work with the BSR presser foot after exiting the function,

the BSR mode that was active at the time of exiting the BSR function will

be activated, even if the sewing computer was turned off in the meantime.

By activating the BSR

function the sewing compu-

ter sews either continuously

at a reduced motor speed

(mode 1, standard) or on

moving the fabric (mode 2).

As long as the BSR presser

foot is illuminated red,

adjustments like threading

and changing the needle, for

example must not be carried

out. The sewing computer is

still in BSR mode and the

needle will engage while

fabric is moved uninten-

tionally!

Without fabric feed the BSR

mode is turned off after

approx. 7 seconds and the

red light goes off.

Please refer to the Safety

Instructions!

032907.52.04_0910_a430/a440/a450_EN

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 85 86

Comments to this Manuals

No comments

Bernina 430 Instruction Manual Page 45

Comments to this Manuals

Related products and manuals for Sewing machines Bernina 430