Bernina Bernette 12 Instruction Manual download pdf (Page 9)

Before connecting the power supply, make

sure that the voltage and frequency shown

Place the machine on a stable table.

1. Connect the power line cord to the

machine by inserting the 2-hole plug into

the

2. Connect the power line plug to the wall

outlet.

3. Turn on the power switch.

4. The sewing lamp will light up when the

switch is turned on.

on the rating plate is conforming with your

mains power.

mains plug socket.

With the sewing machine turned off, insert

the foot control plug into its connector on the

sewing machine.

Turn on the sewing machine, and then

slowly depress the foot control to start

sewing. Release the foot control to stop the

sewing machine.

Caution:

Always make sure that the machine is

unplugged from power source and the main

switch is on "O". when the machine is not in

use and before inserting or removing parts.

Attention:

Consult a qualified electrician if in doubt as

how to connect the machine to the power

source. Unplug the power cord when the

machine is not in use.

Use only foot controller type C-9000

manufactured by CHIEN HUNG TAIWAN.,

LTD. with sewing machine model 20 and 25.

Polarized plug information

This appliance has a polarized plug (one

blade wider than the other), to reduce the

risk of electrical shock; this plug will fit in a

polarized outlet only one way. If the plug

does not fit fully in the outlet, reverse the

plug. If it still does not fit, contact a qualified

electrician to install the proper outlet. Do not

modify the plug in any way.

Connecting the Machine

Foot Control

Machine Setup

8

502020.75.28_021H2D0101_1010_IM_bernette 20 25_EN

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 79 80

Comments to this Manuals

No comments