Bernina Bernette 12 Instruction Manual download pdf (Page 50)

1.0~3.0

Invisible zipper insertion

1/4"

5/8"

Surface

This foot is used to insert invisible zippers so

that they are covered by the seam, and thus

hidden.

Attach the invisible zipper foot to the machine.

Adjust needle center position and straight

stitch. Stitch length depends from the fabric.

Adjust 1,0 - 3,0 mm.

Place open zipper face - down on right side of

fabric as shown picture.

Place the fabric edge at the 5/8 inch marking

line on the needle plate surface.

Place the zipper 1/4 inch below raw edge of

garment.

With right-hand groove of foot over coil, stitch

zipper until the foot hits the slider. Remove the

garment from the machine.

To attach the other half of the zipper, place the

fabric edge on the 5/8 inch marking line on the

needle plate as shown in picture.

With the left-hand groove of foot over coil,

stitch zipper until the foot hits the slider.

Close zipper. Fold the fabric that the zipper is

on ride - hand side out of the way as shown in

picture.

Use a pin for fixing the fabric. Change to

regular sewing foot and saw as close as

possible with straight stitch against the zipper.

At last carry out tie off with some forward

and reverse stitches.

Reverse

Surface

* The invisible zipper foot accessory is

optional. It is not included with this

machine.

Basic Sewing Procedures

49

3.5

502020.75.28_021H2D0101_1010_IM_bernette 20 25_EN

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 79 80

Comments to this Manuals

No comments