Bernina Bernette 12 Instruction Manual download pdf (Page 13)

To open the bobbin cover, slide it against you.

Inserting the bobbin in the bobbin holder with the thread running

counter clockwise direction.

Pull the thread along the arrow marking through the slit under

the finger (A) as far as the pulley (B).

To make sure that the thread is pulled into the tension spring of

the bobbin holder, press a finger slightly onto the bobbin while

pulling. As a check you must feel a resistance in the thread feed.

Pull the thread at the arrow markings into the stitch plate thread

guide from (B) to (C).

To cut off excess thread pull thread back over the cutting off

blade at point (C).

To close the bobbin cover, push it to the back.

Attention:

- Turn power switch to "O" before threading or unthreading the

machine.

- The thread take-up lever must be in the highest position when

threading.

- A wrong threading in can cause damages to the machine!

Inserting the Bobbin

Machine Setup

502020.75.28_021H2D0101_1010_IM_bernette 20 25_EN

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 79 80

No comments

Bernina Bernette 12 Instruction Manual Page 13