Bernina Bernette 12 Instruction Manual download pdf (Page 15)

4. Then further down and around the bottom part of the take up

lever cover.

5. At the top of this movement, pass the thread from right to the

left through the slotted eye of the take-up lever and then

downwards again.

3. Pull the thread forward and down. This operation pulls the

thread into the thread tension.

7. Pull the end of the thread through the needle from front to

rear, and pull out about 10 cm of thread.

Use the face plate thread cutter to cut excess needle thread.

Use the needle threader to thread the needle (refer to next

page for instruction).

6. Guide the thread through the wire loop.

Machine Setup

502020.75.28_021H2D0101_1010_IM_bernette 20 25_EN

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 79 80

No comments

Bernina Bernette 12 Instruction Manual Page 15