249Embroidery Support – Messages
Message
• The attached hoop is too small for this design. Please press
«Edit» button to return to previous screen, change hoop and
press «OK» for hoop detection.
• You have changed the hoop attachment (from «normal» to
«free-arm» or vice versa). Please press «check» button to start
module calibration.
• ADX: Please switch to Embroidery Mode to stitch out the motif.
• Not enough free Space to save Design!
• Design does not fit into hoop!
• Bottom Left Position lies outside of hoop!
• Bottom Left Position.
• Bottom Right Position lies outside of hoop!
• Bottom Right Position.
• Top Right Position lies outside of hoop!
• Top Right Position.
• Top Left Position lies outside of hoop!
• Top Left Position.
• Design Successfully Finished.
• Please switch feed dog to sewing position.
• Please check the upper thread.
•
Bobbin winder is on.
• Please check the lower thread.
• Please lower presser foot.
•
Please raise the presser foot.
• For easier threading it is recommended that the presser foot is
lowered.
• For threading it is recommended that the needle be in the
highest position.
• The sewing/embroidery computer is not functioning correctly.
Please contact your BERNINA dealer.
•
During start-up an error occurred. Please restart the
sewing/embroidery computer. If the problem persists please
contact your BERNINA dealer.
s245-250_e 19.4.2004 16:42 Uhr Seite 249
030794.71.04_0401_a200_EN
Comments to this Manuals