Bernina artista 200 Embroidery Instruction Manual Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 274
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
13The Sewing Computer – Operating Instructions
Threading the Bobbin
place thread on spool pin
attach appropriate spool disc - diameter of spool
disc is disc size
following the direction of the arrow take thread
through the rear guide and around the
pretension stud
wrap the thread around the inner bobbin two
or three times and cut off any excess thread on
the thread cutter
press the engaging lever against the bobbin
the bobbin winder works automatically
the motor stops automatically when the bobbin
is full
remove the bobbin
Winding the Bobbin
turn power switch to
«1» (on)
place empty bobbin
on spindle
Thread Cutter
cut the thread on the
thread cutter
Winding the Bobbin
Winding the Bobbin While Sewing or Embroidering
place thread spool on vertical spool then, following the
direction of the arrow, take thread through the thread
guide on head frame and around the pretension stud
wind the thread several times around the empty bobbin
press the engaging lever against the bobbin
the bobbin winder works automatically
the motor stops automatically when the bobbin is full
remove the bobbin
Note:
For normal sewing, the bobbin
thread does not have to be brought
up as the loose end is just the right
length to start sewing.
To Remove
raise the needle
turn power switch to «0» (off)
open the bobbin cover
grasp the latch of the bobbin case
with right hand
remove case
To Insert
hold the bobbin case latch
the opening on the case should be
at the top
insert bobbin case so that it
engages
close the bobbin cover
Bobbin Thread Cutter
insert the bobbin case
take thread over cutter A
cut thread
Bobbin Case
Caution!
Moving parts – To reduce risk of
injury, switch to «0» (off) before
servicing. Close bobbin cover.
to insert bobbin see page 14
•••••••••••••••••
A
s007-34_e.qxd 19.4.2004 16:09 Uhr Seite 13
030794.71.04_0401_a200_EN
Page view 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 273 274

Comments to this Manuals

No comments