Bernina 710 Owner's Manual download pdf (Page 78)

Practical stitches

The feed dog works accurately when the foot is level.

If the foot is at an angle, e.g. when sewing over thick to thin or vice-versa, the

feed dog cannot grip and feed the fabric. The fabric might jam.

To solve this problem, place one, two or three compensating plates as required

behind the needle under the presser foot to level it.

To correct the height in front of the foot, place one or more plates under the

foot close to the needle. Sew until the foot is level again and remove the

plates.

Height compensation of uneven layers

Sewing corners

Needle stop down.

When sewing corners only a small section of the fabric is actually on the feed

dog. Therefore it cannot grip the fabric well.

Place one or more plates of the height compensation tool parallel to the

presser foot close to the edge of the fabric.

►

the fabric is fed evenly

Due to the width of the stitch plate hole the outer feed dog rows are relatively

far apart.

033805.51.04_2014-02_Manual_B710_EN

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 141 142

No comments

Bernina 710 Owner's Manual Page 78