Bernina artista 165 Embroidery Instruction Manual download pdf (Page 19)

19

Embroidery hoops

Attaching the embroidery hoop

Needle and presser foot

· raise the needle and presser foot

· hold the hoop with the right side of

the fabric facing up and the

attaching mechanism to the left

· pass it under the presser foot

Attaching the hoop

· squeeze the ends of the attaching

mechanism on the side of the hoop

· position the center points of the

hoop (small raisings) over the

bracket of the embroidery arm

·press down on the hoop until it

engages

·release the attaching mechanisms

of the hoop

Removing the hoop

·press both ends on the hoop atta-

ching mechanism towards each

other

· pull up to remove the hoop

Adjusting the embroidery hoop

If the embroidery module was not

bought with the sewing computer

but as a later addition, it is necessary

to adjust the embroidery hoop

before using it for the first time. This

adjustment calibrates the needle to

the center of the embroidery hoop.

Preparation

· the embroidery module must be

attached directly to the sewing

computer without the adapter

· attach the large or medium hoop to

the module with the corresponding

template

Open Setup

·press the external setup button

· the menu appears

· select “Service”

· the menu appears

· select “Adjustment of hoop”

Adjusting the hoop

· the adjustment screen appears

· touch “check”

· the sewing computer follows the

contours of the hoop, finally

positioning the needle in the center

· if the needle does not come to a

stop in the exact center of the

hoop, use the arrows to adjust it

· touch “ok”– close the screen

· close setup with “esc”

· touch “check” in Layout 1 – close

embroidery hoop adjustment

165_170_180_SM_engl 19.04.2004 8:58 Uhr Seite 19

008904.55.04_EMB_0401_a165 a170 a180_EN

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

Comments to this Manuals

No comments