Bernina 1150MDA User Manual download pdf (Page 17)

Inside Corner

Fabric: Firm fabric, 6” x 6”

Needle: 80/12 Universal

Thread: 3 cones of serger thread (blue, red, green)

Presser Foot: Standard

Stitch: 3-thread overlock

Using the small screwdriver and brush/needle insertion tool, remove

the left needle. Snug the needle set screw after removing the needle.

Thread the serger for a narrow 3-thread overlock stitch using thread

colors to match the color-coded threading path on the serger. Adjust

all thread tension settings for a balanced stitch as indicated below.

Inside Corner

This technique works well for continuous plackets on sleeves and

back neck openings.

• Cut an inside corner into the fabric.

• Snip into the corner ¼” (the width of the stitching).

• Serge until the knife reaches the end of the cut.

• Use the handwheel to lower the needle into the fabric.

• Lift the presser foot and straighten the corner towards you.

• Lower the presser foot; continue serging.

Suggested Settings

Upper Looper ····························· 3-5

Lower Looper ····························· 3-5

Left Needle ······························· N/A

Right Needle ····························· 3-5

Stitch Length ······························ 2.5

Cutting Width ····························· 2-3

Differential Feed ························ N

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

No comments

Bernina 1150MDA User Manual Page 17